tag:blogger.com,1999:blog-8371051.post8483065110531215805..comments2023-06-11T02:21:31.803-07:00Comments on Moosteria: 3D: Speeding up the FolgerMoosteronhttp://www.blogger.com/profile/11876161230067008258noreply@blogger.comBlogger1125tag:blogger.com,1999:blog-8371051.post-33366696859302603862015-07-07T17:54:57.634-07:002015-07-07T17:54:57.634-07:00Good stuff, have you actually accelerated? For me ...Good stuff, have you actually accelerated? For me it's heat loss from higher feed to extruding, then cold tip warning, but print head just keeps zooming... So I got jams. <br />Give mor on where this programming logic is on black and while written word; working on fluid mechanics 1.75pla to 0.35 extruder tip, and readinf ohm's law to get right heat dissipation (raised heat to go faster, melted 2 different parts in extruder)<br />Then there is heat conductivity physics laws reading into convection with fan speeds intake CFM or no air density just FLOW density standard SCFM 4o mm fan to extruder at 42ooRPM 4.5CFM, ohm's law for step motor driver, heat conductivity of materials... Bogged down with definitions and few inputs: like unknows data sheet for my PLA/Abs Anonymoushttps://www.blogger.com/profile/10505212950348860133noreply@blogger.com